1. Tape the bottom of the box on the center seam with 2strips of a minimum of 2" wide - pressure sensitve tape.	2. Turn the box right-side up and insertt a red bag. Pull the bag gently over the sides.	3. When the bag is full, twist the top of the bag.
4. Double over the top of the bag and tie it in a single knot. DO NOT push the bag into the box with your hands.	5. Use the cover or flaps to carefully close the box. This will push down the waste.	6. Tape and securely seal the top of the box with at least 2 strips of 2" wide - pressure sensitive tape on the center seam. Place label in the designation area on the side of the box.

U. S. DOT & STATE REGULATIONS:

Please ensure all boxes are packaged as per above diagram & instructions.

All Waste, including liquid containers and sharps containers, must be inside sealed plastic
bag that lines the box.

All free liquid must be in sturdy, highly leak resistant containers. The containers must be tightly
lidded and highly break resistant. All sharps (syringes, needles, scapels and glass products)
must be in rigid and highly punture resistant containers. Be careful not to place objects into
package that will tear the bag.

Each box shall NOT EXCEED a maximum gross weight of 55 lbs per corrugated box.

DO NOT send the following UNACCEPTABLE MATERIALS to BioWaste, LLC as we are prohibited
by regulation and permit; including but not limited to:

RCRA defined Hazardous, Radioactive or Toxic Wastes, Radioactive materials, chemicals, and any substances defined by Federal, State, or Local regulations as Hazardous Wastes which need to be managed by licensed hazardous waste contractors.

Package, secure, and label (with generator label provided) all boxes PRIOR to the drivers arrival.